WOOD PROCESSING AQUA

Use: Multi-Purpose

The Wood Treatment AQUA is aimed at preventive and curative protection of all exterior and interior woodwork.

Properties: High Efficiency - Odorless.

With its new technology makes the Wood Treatment AQUA has better penetration and better attachment of active agents in the wood.

The Wood Treatment AQUA is odorless.

The Wood Treatment AQUA is a curative and preventive.

Wood Treatment AQUA provides the user comfort and safety during application performance and longevity of fungicide-insecticide, against blue stain fungi, decay fungi, insects (termites *) and wood-boring larvae (beetles, beetles, lyctus, ....)
Wood Treatment AQUA can be used indoors and outdoors.

It can be used in painting or spraying

Preparation

On bare wood, clean, dry and free from dirt, no trace of old varnish, sealer, stains, paints or oils

Application

Shake the Wood Treatment AQUA before use
Do not dilute
The period between the layers must be the smallest possible (15 min) to maximize the power of penetration of active ingredients.

On new wood or wood healthy:
Application to the brush 2 or 3 layers ''well fed'' on all sides of the timber to make 1 liter of 5m ². Use a spray gun or a horticultural treat hard to reach places.

Wood attacked: Probing the wood pieces of large section, rub (wire brush) and dust. If necessary, remove and replace parts decayed or weakened. Brush application into 3 layers on all sides of the timber until saturation to make 1 liter of 3m ².
Insist on the damaged parts, assemblies and parts readily available (using a spray gun or horticulture).

Finishes: Wood Processing AQUA is non-greasy and can be covered after drying, all varnishes, lacquers, paints, sealants and pulp wood or veneer finishes Briançon.

Cleaning utensils: WATER
Blot apparatus thoroughly after application. While the wipe.
Rinse with very little water in a container. Let the water evaporate the residue can then be normally thrown in the trash.
Tightly close the container after use.
Place empty container in waste disposal.
Do not discharge into drains.

* The curative treatment against termites must be implemented by a qualified professional.
The wood attacked by termites will be replaced.

Specifications

Types of binding resin: resin waterborne

     * Yield :
       Wood healthy (preventive treatment 1l = 5m ².
       Wood attacked (cure): 1l = 3m ².

     * Drying between 2 layers: 15 min.
     * Complete drying (before finishing): 48 pm

     * Retention: 3 years in unopened container. Store away from frost.
     * Resealed after use.

     * AFNOR Classification: Family I, class 7b2.
     * Density: 1 (20 ° C, according to NFT 30020).
     * Pigmentation: Colorless.
     * Flow: 32 seconds (cut from 2.5 to 20 ° C).
     * Fungicides: Propiconazole and IPBC (iodo propynyl butyl carbamate): 0.6%.

     * Insecticide: Cyperméthrine0.1%

Regulatory information:
Refer to Data Sheet (FDS) (available for on www.briancon-production.com).